MTD WOLF Alpha 95.165 H, Руководство пользователя

Страница: 23 / 284

23
Servicing
EN
Cleaning the grass collector
Attention!
¾
Note the separate operating instructions for the
grass collector.
Î
Detach the grass collector and empty it.
Î
Clean the grass collector with a powerful water jet
(e.g. with a garden hose).
Î
Allow the grass collector to dry thoroughly before
next use.
Maintaining the device
Î
Note the maintenance instructions in the motor
manual.
Î
At the end of each mowing season have the de-
vice inspected and maintained by a workshop.
Note
In the event of an oil change, drop any accu-
mulated waste oil off at a waste oil collection
point or a disposal company.
Note
Return used batteries to your dealer or a dis-
posal company. Uninstall the battery in the
device before the device is scrapped.
Using a jump lead
DANGER !
Risk of explosion / short circuit
¾
Never bypass a defective or frozen
battery with a jump lead.
¾
Also ensure that the devices and the
cable terminals do not come into contact
and the ignitions are deactivated.
Î
Connect the red jump lead to the positive terminal
(+) of the discharged battery and to the positive
terminal (+) of the donor battery.
Î
First connect the black jump lead to the negative
terminal (-) of the donor battery.
Î
Attach the other terminal on the frame near to the
motor block of the lawn tractor as far away from
the battery as possible.
Note
If the donor battery is installed in a vehicle,
the vehicle must not be started during the
jump starting process.
Î
Start the lawn tractor.
Î
Engage the parking brake.
Î
Disconnect the jump lead in reverse order.
Tyre pressure
WARNING !
Increased tyre pressure
Â
Risk of injury and damage to the device
¾
Never exceed the permitted tyre
pressure (see tyre walls).
Î
Check tyre pressure and correct it when required.
Front 0.9 bar
Rear 0.7 bar
Note
Excess tyre pressure reduces the service
life of the tyres. Check tyre pressure prior to
each journey.
After 5 operating hours
Î
Perform the first motor oil change (see motor
manual for intervals).
Î
Use the quick oil drain (optional) to drain the
oil
V
.
Note
When draining the oil, use an appropriate
collection container.
Every 25 operating hours
Î
Lubricate all pivot points and bearing points of the
driving and braking pedals, of the cutting height
adjustment lever and of the PTO lever with a few
drops of light oil.
Î
Clean the battery pole.
Î
Lubricate all blade shafts, clamping rollers and
clamping roller brackets at the lubricating nozzles
with 251H EP-type grease.
Note
Have this work performed by a workshop.
Î
Lubricate the wheel bearings and front wheel
axles at the lubricating nozzles using a multi-
purpose grease.
Î
Lubricate the wheels of the cutting mechanism
at the lubricating nozzles with a multi-purpose
grease.
Î
Dirt and grass residue under the V-belt cover must
be removed by a specialist workshop.