MTD WOLF Alpha 95.165 H, Руководство пользователя

Страница: 14 / 284

14
Assembly
EN
Direction specifications
The direction specifications on the device (e.g. left,
right) are always based on facing forwards.
Assembly
Note
In order to be able to move the tractor, the
gear release lever must be in the appropri-
ate position. See the section "Operation –
Pushing the device".
Attaching the seat
B
Î
Remove the screws and nuts on the seat sup-
port
1
.
Î
Fix the seat support to the mounting bracket
2
using the previously removed screws and nuts.
Î
Press the adjustment lever or open the adjustment
screw (depending on the model)
3
.
Î
Push the seat into a position in which you have
good access to the seat connector
4
.
Î
Attach the connection cable to the seat con-
nector
5
.
Î
Retighten the seat adjustment screw (depending
on the model).
Note
The seat is equipped with a seat-occupation
sensor, which belongs to the safety locking
system. The device can thus only be oper-
ated correctly when the connection cable is
correctly inserted into the seat connector.
Attaching the upper dashboard covering
(model-dependent)
Ca
Î
Insert the tabs (A) of the dashboard covering [B]
into the openings of the dashboard support [C]
1
.
Î
Press them forwards until the stop
2
.
Î
Check the covering fits firmly.
Attaching the motor hood covering
(model-dependent)
C
b
Î
Place the motor hood covering with the re-
cesses [A] on the retaining brackets [B] on the
motor hood
1
.
Î
Press the covering backwards until the stop
2
.
Î
Press both clips [C] slightly upwards to lock the
cover
3
.
Î
Check the covering fits firmly.
Attaching the steering wheel
D
Î
Remove the cover cap [1] (design-dependent) on
the steering wheel.
Î
Place the spacer [6] , the spring [5] and the
washer [4] onto the steering shaft [7] .
Î
Place the steering wheel on the steering shaft.
Î
Fasten the steering wheel using the washer [3]
and the screw [2] (tightening torque: 25-28 Nm).
Note
Put on the washer [3] with the bulge facing
upwards.
Î
Put on the cover cap [1] .
Note
After disassembling the steering wheel
screw, this must be replaced with a new
original screw and screw retention.
Attaching the front bumper
(model-dependent)
E
Î
Remove the four screws from the front bumper.
Î
Fasten the front bumper to the tractor frame (inner
side) using the previously removed four screws.
Putting the battery into operation
DANGER !
Risk of fire, explosion and corrosion posed
by battery acid and gases from battery acid
¾
Battery acid is corrosive. Clean all device
parts immediately which are sprayed with
battery acid.
¾
Do not smoke, keep burning and hot
objects at a distance.
¾
Charge batteries only in well-ventilated
and dry areas.
¾
Possible short circuits when working on
the battery. Do not place any tools or
metallic objects on the battery.