MSI MSI-3460, Руководство оператора

Страница: 33 / 60

Calibration 29
5.1 Initial Calibration
Use this procedure only if the capacity and count by (d) needs to be modified. The
initial steps of the initial calibration will totally erase user setups as well as any
previous calibration.
1) Turn the 3460 off.
2) Remove the seal screw. With
a small screwdriver press and
hold the
CAL switch behind
the seal screw.
3) Still holding down the CAL
switch, press the POWER
switch.
4) The display blinks rESEt .
5) To reset all calibration
constants and setup
parameters, press
TARE .
6) The 3460 requests a
confirmation by displaying
Sure? .
To cancel the Reset press
the POWER key.
7) To complete the reset, press
TARE . The Calibrate menu
appears. You must now
recalibrate the system.
8) Press TARE to start the initial
calibration procedure. The
display shows
Unit . You
select the units you wish to
calibrate in.
9) Press TARE to select the
calibration unit.
10) Select the USER
key to choose
between lb and kg. When the
desired unit is shown, press
TARE .
11) Next, set the capacity in the
selected units. Capacity must
be set no higher than the load
cell rated capacity.
12) Press TARE to enter the
capacity setting screen. A
capacity of 10000 is the initial
value.
If 10000 units is the desired
capacity press TARE and skip to
step 16.
13) To change the capacity, press
USER .
Initial Calibration
Resetting Capacity and Countby (d)
Cal Switch
LO BA
CAL
Remove
Hex Seal
Screw
Press Switch
behind the hole
with a small
Screwdriver
CAL
UHVHW
blinking
6YUH"
&$/
8QLW
8QLW
blinking
kg lb
USER
F
&$3
TARE
TARE
TARE
TARE
TARE
TARE
blinking
USER
F
blinking
Error Correction: If you input a
wrong value, press
ZERO to step
back one digit and reenter.
To enter a decimal point, push
POWER while the digit is blinking.
Figure 5-4. Initial Calibration