MSH equipment CA Eco 40, Руководство пользователя

Страница: 12 / 34

Eco 40-55-75 manual revision 01/10 12
4.6.2 ELECTRIC CONNECTIONS
Figure 4.6.3A- Electric System Layout
POWER SUPPLY
Exhauster electrical connections are at the
Customer's charge, under its own responsibility.
The electrical connections of the Exhauster shall
consider:
•
the Laws and Technical standards applicable
at the time of installation in the place of
installation;
•
data indicated on " Nameplate A ".
Make the electrical connections.
Supply power to the machine with a separate line of
suitable cross-section, also providing suitable
protections for direct and indirect contact.
This line
and the relevant protections are at the
Customer's charge.
•
Power cord is with double insulation and of
suitable cross-section (approx. 3m long) and
completed with ground wire.
•
Control cable or for remote starting shall have
a section of 2x1.5 sq.mm (approx. 3m long)
and shall be connected to electric item
microswitch line.
The electrical system design and components ensure utmost dependability and safety of use. The attached
wiring diagrams will allow identification of all connections and components. Only make the required
electrical connections; do not modify any circuits, calibrations, components, etc. Failure to follow this
warning will be considered as tampering. Before connecting to the mains, ensure that power voltage and
frequency correspond to the specifications indicated on the nameplate.
Perform ground connections
and/or zero setting as required by the prevailing laws of the country.