Model IR4000S
7
3.0 Installation
CAUTION:
The IR4000S Single-Point Monitor contains components that can be
damaged by static electricity. Special care must be taken when wiring the system to
ensure that only the connection points are touched.
Installation and Maintenance must be carried out by suitably skilled and competent
personnel only.
Special Tools
5mm Allen wrench for lid (included with unit).
0.1” flat-head screwdriver for terminal block connections (included with unit).
Adjustable wrench for conduit or cable gland connections (not included).
Installation Step
Refer to Section
1. Unpack the equipment and prepare for installation
Section 3.1
2. Attach each IR400 to a junction box or directly to the
IR4000S
Section 3.3
3. Mount the IR400, IR4000S units in place. (Steps 3 and
4 can be swapped if it is easier to attach cabling before
the units are mounted in place.)
Section 3.2
4. Wire the IR4000S to the IR400 and any remote devices
Section 3.3
5. Power on the equipment
Section 3.4
6. Gas check or calibrate the IR400
Section 4.2 or 4.4
Table 1: IR400/IR4000S Installation Overview
3.1 Unpacking the Equipment
All equipment shipped by General Monitors is packaged in shock absorbing containers,
which provide considerable protection against physical damage. The contents should be
carefully removed and checked against the packing list.
If any damage has occurred or there is any discrepancy in the order, please notify
General Monitors as soon as possible. All subsequent correspondence with General
Monitors must specify the equipment part number and the serial number. Both are on the
cover of the IR4000S.
