MRMC MRMC-1465-06, Быстрый старт

Страница: 15 / 28

Pan Bars Quick Start Guide
11
The keywords used in the above table are described below:

*NetworkBoards
: The number of network boards (nodes) in
the system. You need to increase this by one (1) to cater for the
new board in the Pan Bars mimic device.

*NodeProgram3
: For the node to which you assigned the
mimic (node 3 in this case), add a reference to the
.btl
file
that you want Flair to load into the mimic device on that node
when starting up. The
.btl
file is already supplied with Flair
so you don’t need to copy or download it from elsewhere.

*MimicBoard1
: Assigns mimic board 1to an available node.
You need to specify a node that is not already used by another
board. In this example nodes 1 to 2 are already used by other
boards so
*MimicBoard1
is assigned to node
3
. If you need to
add another mimic board, you can add a line
*MimicBoard2:
4
.
Remember to save the file after you have edited it.
3. In the Flair menu, click on Setups > Network Setup .
4. In the pop-up, click on the Find button.
5. In the Find results, find the IP address of the Pan Bars
(
192.168.1.236 in this example), and copy it into the node that you
assigned to the Pan Bars mimic device ( Node 3 in this example):
If using a Mimic box to covert raw encoder data to Ethernet, insert
the following lines in Flair.ini:
*NetworkBoards: 3
*NodeProgram3: Quad6Ether_II.btl
*MimicBoard1: 3
*Autorecalibrate:True
*LoadfromHC:True