MRMC MILO MRMC-1100-00, Быстрый старт

Страница: 30 / 44

Milo Quick Start Guide
26
6. Push the rig to the track and whilst in the position push the four
track bearings under the four corners of the Milo base making sure
that all four bearings are aligned with the corners of the Milo base,
and the track motor gear on the underside of Milo clears the rack.
(The track motor gear is on bearing rails so you can slide it out of
the way to clear the rack.)Drop the four track bearing bolts in their
slots in the Milo without tightening them yet ensuring they line up
with the track bearings. Lower the casters on each corner to allow
the bolts to be tightened by two turns into the bearings.
7. Lower Milo further on to the bearings on the track so it drops fully.
Tighten the four track bearing mounting bolts at the corners.
8. Feed out enough umbilical cable from your control area to reach the
entire length of the track without stretching the cable. Make sure the
area alongside the track is clear so that the umbilical cable doesn’t
catch on anything when Milo drags it alongside the track.
9. Attach the track motor pinch wheel on the underside of Milo,
described in the next section.
Hint
Always mount and remove the track bearings with care. Try to
keep them squared up and in-line with the bearing rail to avoid
damaging them or loosing a bearing.
Caution
Manually push the rig to ensure there is no resistance in the track. If
there is, you might need to level the track.