MRMC MILO MRMC-1100-00, Быстрый старт

Страница: 31 / 44

Milo Quick Start Guide
27
Attaching the track motor pinch wheel and its connectors
1. On the separately supplied pinch wheel assembly, remove the brass
retaining pin by pulling on the ring.
2. Mount the pinch wheel assembly onto the track motor on the Milo
underside, by sliding the track motor gear against the rack (the
motor is on bearing rails) and putting the pinch wheel Socket onto
the track motor Mounting bar.
3. Replace the retaining pin in the pinch wheel assembly by pushing on
the ring (not the locking sleeve), to hold the assembly in place on
the track motor.
4. Hand-tighten the pinch wheel adjustment bolt so that the rubber
wheel presses firmly against the smooth side of the rack. This holds
the track motor gear firmly against the toothed side of the rack.
5. The pinch wheel assembly has sensors for detecting the Limit (L)
and Datum (D) magnets on the track. Connect the cables for these
sensors to the corresponding connectors on the Milo underside, and
use cable ties to hold them securely up away from the track.
Hint
Do not tighten the pinch wheel too much to prevent damage to the
pinch wheel. It should only be so tight that you are able to turn the
wheel and then do about an additional half turn.
Mounting bar
Socket
1
2
5
4
2
3