MQ Power WHISPERWATT DCA180SSK, Руководство по эксплуатации и запасным частям

Страница: 56 / 98

PAGE 56 — DCA-180SSK — PARTS AND OPERATION MANUAL — REV. #3 (06/11/09)
Generator Storage
For storage of the generator for over 30 days, the following
is required:

Drain the fuel tank completely, lubricate and change oil.

Disconnect the negative terminals of the battery and
cover it, or remove it from the machine and store it
separately.

If the ambient temperature is expected to drop below
0
o
C, add antifreeze to the radiator.
Removal from long term storage:

Apply oil to the engine valve and rocker arms, and
examine the operating condition of the valves.

remove the oil filler pipe from the turborcharger oil inlet
port, add 0.5-1L (0.13-0.26gal) of oil to the turbocharger,
reinstall the oil filler pipe.

Change the oil in engine oil pan.

Replace all the filters.

Flush the inside of the cooling system.

Drain the water from the fuel tank and bleed the air from
the fuel system.

If the engine has not been started for more than one
year, contact your Komatsu distributor to have engine
overhauled.
7. After bleeding the air, tighten air bleed plug, then push in
the knob of feed pump and lock it in position.
8. Replace Corrosion resistor cartridge (if equipped)
9. Screw in valves at the top of the corrosion resistor.
10. Using a filter wrench, turn the cartridge to the left to
remove it.
11. Coat the seal surface of the new cartridge with engine
oil and install it to the filter holder.
12. Tighten until he packing surface contacts the seal
surface of the filter holder, then tighten a further 2/3 of a
turn.
13. Open valves.
Cleaning breather element
1. Loosen the clamp, then remove the hose and take out
breather. Wipe off the dirt around the breather. Check
the O-ring, and replace if necessary.
2. Wash the breather in diesel fuel or flushing oil, blow dry
with compressed air, then reinstall it.
3. Inspect the hose and if there is any deteriorated oil stuck
inside the hose. Replace hose if necessary.
Greasing
Using a grease pump, grease the fan hub (1 place) and
tension pulley (2 places).
DCA-180SSK — MAINTENANCE