MPV MN 11, Руководство по эксплуатации

Страница: 17 / 21

09/ 2007

Electrical danger!
Maximum circuit voltage for a measured current of 600 V! In
the case of a safety triggering in excess of 600 V, damage to the
appliance may be caused. A damaged appliance may represent
an electrical hazard!
8.2.1 Voltage measuring
- Use the rotary switch

to select the required function (V) on the
01
- Using the button (blue)

select the voltage type to be measured on the
01 : direct current (DC) or alternating current (AC).
- The black safety measuring cable has to be connected to the COM jack

on the 01
- The red safety measuring cable has to be connected to the jack for V,

,
Hz, °C,

on the 01
- Bring the safety measuring lines into contact with the measuring points, read
off measured value on the digital display

unit of the 01 .
See figure 2: Direct voltage measurement
See figure 3: Alternating voltage measurement
8.2.2 Current measuring
- Use the rotary switch

to select the required range and function (mA or A)
on the 01 .
- Using the button (blue)

select the voltage type to be measured on the
01 : direct current (DC) or alternating current (AC).
- The black safety measuring cable has to be connected to the COM jack

on the 01 .
- The red safety measuring cable has to be connected to the jack for the mA
range,

for currents up to 200 mA or with the jack for 10 A range

for
currents greater 200 mA to 10 A on the 01 .
- Bring the safety measuring lines into contact with the measuring points, read
off measured value on the digital display

unit of the 01 .
See figure 4: Direct current measurement
See figure 5: Alternating current measurement
8.3 Resistance measurement
- Using the rotary switch

select th­e required function (Ω) on th­e
01 .
- If necessary, use the button (blue)

to select th­e function LVΩ (reduced
measurement voltage: 0.6 V).
- The black safety measuring cable has to be connected to the COM jack

on the 01 .
- The red safety measuring cable has to be connected to the jack for V, Ω ,
Hz, °C,

on the 01 .
- Bring the safety measuring lines into contact with the measuring points, read
off measured value on the digital display

unit of the 01 .
See figure 6: Resistance measurements
8.4 Diode test
- Use the rotary switch

to select the required function ( ) unit of the
01 .
- The black safety measuring cable has to be connected to the COM jack

on the 01 .
- The red safety measuring cable has to be connected to the jack for V, Ω ,
Hz, °C,

on the 01 .
- Bring the safety measuring lines into contact with the diode connec-
tions, read off measured value on the digital display

unit of the
01 .
- For a standard Si diode applied in conduction direction the conduction volt-
age between 0.400 V to 0.900 V is displayed. The display “000” indicates a
short circuit in the diode, display values > 2 V indicate an interruption in the
diode.
- For a diode applied in reverse direction “OL” is displayed. If the diode is
defective, values < 2 V are shown.
see figure 7: Diode test
8.5 Continuity testing with buzzer
- Use the rotary switch

to select the required function ( ) on the
MN 11 .
- Using the button (blue)

carry out the switchover to continuity testing on
the MN 11 (press key once)
- The black safety measuring cable has to be connected to the COM jack

0XOWLPHWUH01PSYQRWLFHSGI
www.motor-pump-ventilation.com