MP Systems CDR80, Установка, эксплуатация и обслуживание

Страница: 10 / 45

2.1. General Rules
The CDR Series has been designed and constructed in such a way to minimize any
possible cause of danger to the operator and their surroundings. However, residual risk
remains and can arise through improper use of the machine and can be of various
types:
•
Risk due to escaped coolant/cutting fluid.
•
Risk due to excessive noise caused by operating outside permitted limits.
•
Risk of accidents caused by scraping against edged sheet metal profiles.
2.2. Prevention of Mechanical Risks
In operation, the CDR Series contains some moving parts. These parts constitute a
possible source of danger to the operator, therefore to avoid any possible danger it is
necessary to observe the following operational rules:
•
Before removing any panels/guards, ensure electrical supply to the machine
has been switched off.
•
Never start the CDR Series with any panel/guards removed.
•
The additives present in coolant/cutting fluid may have a corrosive action
that can irritate the skin and eyes.
o
Always wear gloves & eye protection when handling coolant/cutting
fluid.
2.3. Prevention of Electrical Risks
When power to the machine is switched on, the machine is a source of danger,
especially if the basic safety rules are not followed. To avoid any possible danger, it is
necessary to observe the following basic operation rules:
•
When making electrical connections to the CDR Series, observe state and
federal electrical codes or those otherwise in force. Observe the technical &
electrical supply conditions imposed by the power supply companies.
•
Before carrying out any work on the CDR Series, switch off the electrical
supply at the main isolator.
•
Work on the CDR Series must only be carried out by authorized personnel.
•
Always replace worn out or defective components.
•
Before working on electrical equipment always read the manual that
contains the machines circuit diagram.
•
Always make sure there is no electric power to the equipment.
•
Check to ensure the machine is earthed before powering on the CDR
Series.
•
Check all electrical connections and connecting cables are well insulated
and replace any cables that are evidently worn or damaged.
•
Be sure to use power cables supplied by MP SYSTEMS or that have been
approved by MP SYSTEMS .