Moxa VPort 364 Industrial Video Encoder
Getting Started
3-3
NOTE
The PTZ control protocol is not standardized. To use a particular PTZ control protocol, the video server must
support the driver for that protocol. Currently, the VPort 364 supports PTZ control protocol drivers for:
1.
Pelco D
2.
Pelco P
3.
DynaColor DynaDome
4.
Cohu
If you need to use a protocol that is not on the list, contact the manufacturer of the camera to get the PTZ
control commands, and then program its PTZ control using the VPort 364’s Custom Camera function.
NOTE
The VPort 364 comes with a PTZ driver upload function for implementing new PTZ drivers. Please contact a
Moxa sales representative if you need assistance from Moxa’s R&D department to create a new PTZ driver.
NOTE
The “Transparent PTZ Control” function in the camera driver list is used to transmit the PTZ control signal over
a TCP/IP network to the VPort D361 video decoder or PC (additional driver required). The PTZ control panel or
keyboard can directly control the PTZ camera or device, eliminating the need for a PTZ camera driver and
allowing the use of PTZ cameras with the VPort encoder.
Step 5: Configure the VPort 364’s IP address
After powering on the VPort 364, wait a few seconds for the POST (Power On Self Test) to run. The STAT LED
turns green to indicate that the POST process has completed. The IP address will be assigned when the 10 or
