Moxa MXNVR-RO
Hardware Connection Description
3-3
Connecting the Power
Connect the 24 to 110 VDC power line with M12 connector to the MXNVR-RO-T computer. If the power is
supplied properly, the Power LED will glow a solid green after 25 to 30 seconds.
Grounding the Unit
SG: The Shielded Ground (sometimes called Protected Ground) contact is the central
pin of the power input connector. Connect the SG wire to an appropriately grounded metal
surface.
Connecting Data Transmission Cables
Two 10/100/1000 Mbps Ethernet ports using M12 X-coded connectors are located on the rear panel.
ATTENTION
Do NOT remove the power supply during a BIOS upgrade, since doing so may cause the system to crash.
ATTENTION
When you use a USB drive larger than 4 GB, you will need to convert the file system type to FAT32.
The following figure shows the Ethernet port location on the rear panel.
Follow the steps below to connect an M12 X-coded cable:
1.
Obtain an M12 X-coded cable.
The following table shows the Ethernet connector and cable options. For more information, please contact
your local Moxa sales representative.
Model Name
Type
Description
CBL-M12XMM8PRJ45-BK-100-IP67 Cable and connector 1-meter X-coded M12-to-RJ45 Cat-5E UTP
Gigabit Ethernet cable, 8-pin male M12
connector, IP67-rated.
M12X-8PMM-IP67
Connector
Field-installation X-coded screw-in Gigabit
Ethernet connector, 8-pin male, M12
connector, IP67-rated.
