M o d e S e l e c t i o n s
This feature is designed for auditing the torque applied to a fastener for
a test such as determining relaxation after a fastener has been tight-
ened. An angle enabled transducer is required to operate in this Mode.
An initial and final torque threshold is entered into the bolt audit mode
fields and the angle required to move between these 2 thresholds is
reported. See page 14 for setting up Bolt Audit
Bolt Audit*
Bolt Audit 1500 Hz
+20.010
lbf.in
Menu Tool Tests
This feature is designed for auditing the operation of a Spindle Tool. An
angle enabled transducer is required to operate in this Mode. The unit
checks the Torque and Angle setting of a Spindle. When the spindle
stops, the PTT will display and record the final angle, and final peak
torque. See page 15 for setting up Spindle Audit.
Spindle Audit
+7.6261
Note:
* The Bolt Audit Mode is an additional feature that is only available
with PTT Bolt Audit model (Item # 072995)
Spindle Audit 1500 Hz
+18.969
lbf.in
Menu Tool Tests
+2.8723
Corporate Headquarters:
1080 North 11th Street, San Jose, CA 95112 Phone: (408) 292-2214 Fax: (408) 292-2733
www.etorque.com
Page 9
E n v i r o n m e n t a l C o n d i t i o n s
Operating Temperature: 0 Degrees Centigrade to 50 Degrees Centigrade
Storage Temperature: -20 Degrees Centigrade to 70 Degrees Centigrade
Humidity: Maximum of 95% Relative Humidity
