12
99286GB- XMODE – USER MANUAL - REV. 01
8 - LOCK OPERATION WITH KEYPAD AND TAG KEYS
To open the door from outside, open the lock by entering the personal access code followed by
E
or by placing an activated TAG key close to the
external escutcheon.
To open the door from inside, press (
E
) on the internal escutcheon or enter the inside security code sequence (if set) or use the optional external
peripheral (remote button, remote control, access control system, etc.) (if installed).
See points 15 and 16 for information on the acoustic and light signals.
Repeated attempts (5 in less than 12 seconds) to enter unknown codes or repeated attempts (10 in less than 25 seconds) to open the
door with unknown TAGs will put the lock in security mode. Codes and TAGs will no longer be accepted/read for a preset time. The YEL-
LOW LED (in addition to the door status LED) will flash and a beep will sound every second.
When the (E) key is pressed, if all the LEDs (RED, YELLOW, BLUE, GREEN) light up on the internal escutcheon for 2 seconds and the lock
does not open/close, it means that the inside security code is active (see paragraph 6.2).
8.1 - MEMORIZING PERSONAL ACCESS CODES
8.2 - DELETING A PERSONAL ACCESS CODE
The code should be easy to remember but hard to discover: we recommend using all 8 available
digits.
New locks do not have a preset code.
- Enter programming mode as described in point 4.
- Press the “
P
” key to enter code programming mode. Enter a code composed of a minimum of 3 to a maximum
of 8 digits, then confirm by pressing (
E
). The flashing GREEN LED accompanied by 3 high-low sounds confirm
that the code has been memorized. The flashing RED LED accompanied by 2 high-low sounds means that the
entered code is already in memory. The same signals are given if the code has less than 3 or more than 8 digits
or if the “
P
” key is pressed in this phase.
- Enter programming mode as described in point 4.
- Press the
DOWN arrow
(
) key until an acoustic signal warns that you have entered the deletion menu.
- Press the
DOWN arrow
(
) key again until a long acoustic signal warns that you have entered the numerical
code deletion menu.
- Enter the code to be deleted and press “
E
” on the external escutcheon to confirm. The flashing GREEN LED ac-
companied by 3 high-low sounds confirm that the code has been deleted. The flashing RED LED accompanied
by 2 high-low sounds means that the entered code was not present in memory.
- Repeat the above procedure if you want to delete other codes.
When done, exit programming mode by pressing (
E
) on the internal escutcheon; the system will automatically
exit programming mode after 30 seconds.
- Repeat the above procedure if you want to memorize other codes (max. 100 different codes).
When done, exit programming mode by pressing (
E
) on the internal escutcheon; the system will automatically
exit programming mode after 30 seconds.
Содержание Xmode F1.0
Страница 19: ...19 NOTE ...
Страница 20: ...99286GB 06 14 a_013334 SAFEGUARDINGYOUR SECURITY www mottura it ...
