AX34509b_e.doc / Mrz-16
Page 33 / 38
When you read the x-value of your first interpolation point in the display, press “Cmd”
again. This will automatically store the actual display value to the P01_x register, and
for about 1 second you will read “P01_y “ on the display, followed again by the same
reading stored previously.
This display value now can be edited to the desired P01_y value, like a regular
parameter
When you read the desired P01_y value in your display, store it by pressing “Cmd”
again. This will automatically cycle the display to the next interpolation point P02_x.
The unit will examine the constraint valid for the x-values of interpolation points.
Every interpolation point must be higher than its preceding point.
Where this constraint is breached, all 6 decimal points will blink automatically as a
warning. Pressing the CMD key will not store the illegal value, but result in an error text
"E.r.r.-.L.O." as a warning.
Once you have reached and stored the last interpolation points P16_x/y, the routine will
restart with P01_x again, and you are free to double-check your settings once more.
To conclude the Teach procedure, press the ENTER key. As a result you will read “StOP”
for about 2 seconds, before the unit returns to the normal operation. All linearization
points will at the same time be finally stored.
