AX34509b_e.doc / Mrz-16
Page 11 / 38
4.
How to Operate the Keys
The unit uses 3 front keys for all setup operations. Subsequently, the key functions will be
named as shown in the table below.
ENTER
SET
Cmd
(Command)
The functions of the keys are depending on the actual operating state of the unit.
The following three operating states apply:
Normal display state
Setup state
a.)
Basic setup
b.)
Operational parameter setup
Teach operation
4.1.
Normal display state
You can change over to the other states while the unit is in the normal display state only.
Change over to
Key operation
Basic setup
Keep ENTER and SET down simultaneously for 3 seconds
Operational
parameter setup
Keep ENTER down for 3 seconds.
Teach operation
Keep SET down for 3 seconds
The Cmd key is only used for execution of the Tare function, the Reset function and for
Teaching the interpolation points for linearization (see section 8).
