6
REAR VIEW
The Rear Panel consists of a
MAIN POWER
and
CONTROL CABLE
connector,
TO
RECEIVER
and
TO MOUNT
F-Connectors. The Nomad SD Controller differs from the
Nomad SD2 in that the SD Memory Card Slot is located in the rear of the unit between the
Control Connector (9 pin) and the “To Receiver” F-type connector.
CONNECTIONS
12 VDC:
Pr/- 12 volt DC input power for Controller and
Mount operation.
Control Cable:
Sends +/- 12 volt DC power to the Mount motors and
receives positioning information from the dish.
To Receiver:
This cable routes the TV signal to the Satellite Receiver (see the label on
the bottom of the Controller.)
To Mount:
This cable routes to the Roof Mount to provide LNB power (see the label on
the bottom of the Controller.)
NOTE:
For
DirecTV
5 LNB Slim Line High Definition receivers that require a
B-Band Converter (BBC),
install it
before
the Controller.
For
Dish Network
receivers that use a
Separator
, install it
after
the
controller.
12 VDC Control Cable
To Receiver To Mount
