11
SETTING SERVICE AND MOUNT TYPE
Using the Front Panel
(With Version 29 Software or greater)
This process is only needed to be done only once per installation. It is used to marry the
controller to the mount.
CAUTION!! Do not confuse this software with any earlier versions. If you have a
NomadSD.dat file on your Memory Card
Remove
it from the Root Directory FIRST.
Failure to do so will cause your stored Configuration data to be overwritten by this data
thus preventing any programming that you may do through the front panel.
The Nomad SD/SD2 Controller can be programmed in the steps listed below.
The
STOW, FIND and the POWER
buttons will allow you to configure your controller.
NOMAD SD2 CONTROLLER
Entering into the
Configuration Mode
•
Hold down the
STOW and FIND buttons
then press the
POWER ON button.
Release
the POWER button but
continue to hold
the STOW and FIND buttons for an additional
10 seconds or until you see the STOW and FIND LED’s
turn OFF
,
then turn ON again
-
then release all buttons. You are now ready to proceed with the configuration process.
If the above does not happen, repeat the process until it does. This will put the controller
into the Configuration mode.
STOW FIND
POWER
