Quick Reference Guide
9
2.
Route the power input cable from the cradle’s
power port to the connection point for the
vehicle’s power source.
NOTE
The ideal location for connecting
the vehicle cradle power input cable
would be an accessory output in your
vehicle’s fuse panel. The vehicle cradle
should be added to a circuit with a
maximum load capacity for the cradle and
the original circuit. Refer to the vehicle’s
Owner’s Manual
for identification of the
circuit.
If a fused output is not available, the
vehicle cradle must be installed with the
provided in-line fuse holder and UL Listed
5A fuse. The fuse protects the vehicle
from an electrical short on the power line
to the cradle.
To use the cradle to charge the
MC9500-K, when the vehicle’s ignition is
off, connect the cradle to unswitched
power.
NOTE
The means of routing and
securing the power input cable from the
cradle through to the vehicle power
source is extremely important. Hazards
associated with improper wiring can be
severe. To avoid unintentional contact
between the wire and any sharp edges,
provide the cable with proper bushings
and clamping where it passes through
openings. If the wire is subjected to
sharp surfaces and excess engine
vibration, the wiring harness insulation
can wear away, causing a short between
the bare wire and chassis. This can start
a fire. To avoid any mishaps, all wiring
should be routed away from moving
parts, high temperature areas and any
contaminants.
