Motorola SE3300, Руководство по интеграции

Страница: 53 / 74

Control Interface 5 - 9
WR_OSC 0x52
Writes directly to the oscillator IC registers. Refer to the DS1086L oscillator specification from Maxim
(
http://www.maxim-ic.com ) for register descriptions.
Note that the SE3300 controls many oscillator registers. Using this command to write registers may conflict
with SE3300 requirements, causing unpredictable behavior.
WR_SCRIPT 0x76
Programs more than one SE3300 command into a script, which can be executed using a single command
(EXECUTE_SCRIPT). Use this method whenever possible to increase performance and timing
synchronization.
There are ten scripts (Script-0 through Script-9) and a total of 150 bytes for all scripts. Exceeding these limits
results in a NAK status code. The general format for this command is:
<0x76><Script#><Len> [ <C
1
Len><C
1
Op><C
1
Data> ] [ <C
2
Len><C
2
Op><C
2
Data> ]
[<C
3
Len><C
3
Op><C
3
Data> ] <Checksum>
Example
To program script 2 with AIM_ON, ILLUM_ON, and ACQUISITION_ON, format the WR_SCRIPT command as
follows:
<0x76><0x02><0x09> [ <0x02><0x55><0x01> ] [ <0x02><0x59><0x01> ] [ <0x02><0x58><0x01> ]
<0x70>
WR_SENSOR 0x50
Writes directly to the Micron MT9V022 sensor registers. Refer to the MT9V022 specification from Micron for
register descriptions.
Note that the SE3300 controls many sensor registers. Using this command to write sensor registers may
conflict with SE3300 requirements, causing unpredictable behavior.
NOTE Brackets ( [ ] ) appear in this example for clarity only, and are not part of the commands.