Motorola RPU2160, Инструкция по установке и эксплуатации

Страница: 60 / 80

REPEATER CLONING
48
User Guide
Note: After cloning is completed, the RDX radio
will sound either a “pass” tone (cloning was
successful) or a “fail” tone (cloning process
has failed). The “pass” tone sounds like a
good key “chirp” whereas the “fail” tone
sounds similar to a “bonk” tone. If the RDX
radio is a display model, it will either show
“Pass” or “Fail” on the display (a tone will be
heard within 5 seconds).
6. Once you have completed the cloning
process, turn the RDX radio OFF and ON to
exit ‘clone’ mode.
7. Turn the repeater OFF and ON to exit “clone”
mode.
- If the RDX channels contains
frequencies that are not
within the repeater TX or RX
frequency range, the
repeater will not work on
these channels.
- In the RDX radio, make sure
that in each one of the TX/
RX frequency pairs, the
bandwidth setting has
exactly the same value. For
example, if in Channel 7 the
TX bandwidth separation is
12.5 KHz, then the
corresponding RX
bandwidth separation in this
same channel 7 should be
also 12.5 KHz.
Important