In the illustrated diagrams below and on the following page, are represented the
procedures for proper installation of the motor KVM25.
04
.
INSTALLATION
▷ AUTOMATISM INSTALLATION
AUTOMATISM INSTALLATION ◁
04
.
INSTALLATION
04.A
04.B
It is very important that these quotas are respected! Only in this way the
correct functioning and durability of automatism can be assured!
↑ 01
- Place the pinion on the Ø25mm
spring’s shaft of the sectional door.
← 02
- Place the chain over the pinion
leaving it hanged.
↓ 03
- Pass the Ø25mm shaft through
the bearing on the support plate .
← 04
- Slightly loosen the bearing
bracket’s screws (left),to be able to
move it sideways.
← 05
- Pull the metal plate to the wall
and secure with the screws.
After fixing the plate, tighten the
bearing bracket’s screws back to fix it
too.
↓ 06
- Pull the pinion to the bearing and
tighten the two bolts to secure the
pinion to the shaft.