In the illustrated diagrams below and on the following page are represented the
procedures for proper programming of the motor KVM25 limit switches, once installed
on the gate.
05
.
PROGRAMMING
▷ PROGRAMMING LIMIT SWITCHES
It is very important that these quotas are respected!
Only in this way the
correct functioning and durability of automatism can be assured!
PROGRAMMING LIMIT SWITCHES ◁
05
.
PROGRAMMING
06.A
06.B
05
- Move the close magnetic actuator
near the sensor until the red LED lights up.
This indicates that the limit switch will
activate in that exact position.
06
- Manually move the door to the
open position.
07
- Move the opening magnetic actuator
near the sensor until the red LED lights up.
This indicates that the limit switch will
activate in that exact position.
Now tighten the 4 screws of the magnetic
actuator.
08
- Lock the motor and test the door
opening and closing using either the
"PUSH" button on the control board or the
transmitter. If necessary, repeat the
previous steps, from the image 03, to
better tune the limit switches.
01
- Unlock the motor, pulling the lever
down. You will hear a little click when
pulling down, and then you must let the
lever go up.
02
- Open the automatism cover with a
screwdriver and connect the motor to a
power source at 230V.
03
- Slightly loosen the 4 screws of the
magnetic actuator.
04
- Manually pull the door into the closed
position.
