1▷
Click once on the LEARN button and
the LEARN LED will light up.
2▷
Press once on the transmitter’s button
you wish to operate. The LED will flash
three times, indicating successful
programming.
NOTE:
To program multiple transmitters,
repeat the same steps for each transmit-
ters.
▷ MOTOR INSTALLED ON LEFT SIDE:
6A▷
This potentiometer adjusts the
motor’s power when closing
6B▷
This potentiometer adjusts the
motor’s power when opening
▷ MOTOR INSTALLED ON RIGHT SIDE:
6A▷
This potentiometer adjusts the
motor’s power when opening
6B▷
This potentiometer adjusts the
motor’s power when closing
05
.
PROGRAMMING
▷ DESCRIPTION
▷ DIP-SWITCHES
POTENTIOMETERS AJUSTMENT ◁
TRANSMITTER PROGRAMMING ◁
1▷
Press and hold the LEARN button for eight seconds.
The LEARN LED will flash three times, indicating the success of the operation.
RESET CONTROL BOARD’S MEMORY ◁
05
.
PROGRAMMING
07.A
07.B
CONTR
OL BO
ARD
01 ▷ Battery Input (A - Positive | B - Negative)
02 ▷ Transformer Input
03 ▷ Motor Cable Input (A - Black | B - Red)
04 ▷ Dip-Switches
05 ▷ Connector J5
06 ▷ Force ajusting potentiometers
07 ▷ Button “
PUSH
”
08 ▷ LED “
LEARN
”
09 ▷ Button “
LEARN
” (programming button)
Dip 1
Dip 2
Automatism is installed on the
right of the gate (seen from inside).
Automatism is installed on the left of
the gate (seen from inside).
Enable automatic closing.
(Pause time 1 minute fixed)
Disable automatic closing.
ON
(UP)
OFF
(DOWN)
[MX4SP]
1A
1B
2A
2B
3A
3B 4
5
7
8
9
6A
6B
6A
6B
[MXS4SP]
