11
2
3
4
1
EN
03. INSTALLATION
BAR MOUNTING
Make the connection between the cable that goes out through the barrier shaft and the LED
cable on the bar.
*Connect the cable pins correctly and tighten the union thread to secure the connection.
(Safety Band connections are optional)
Fit the remaining pieces in the order shown in the picture.
Route the cable that comes out of the barrier shaft through the hole in the assembly you
assembled.
Secure the parts to the stem clamping plate with screws and bolts provided in the package.
Keep the attached cables inside the bar cover and secure the
cover to the barrier with the two remaining screws.
Apply the label to hide the screws.
4
2
3
•
REVERSE BAR SUPPORT
1 •
Make sure that the bar holder position corresponds to the
motor position (stretched or retracted) according to the images
above.
2 •
Remove the support by unscrewing the two bushing pins.
3 •
Replace the support on the shaft in the correct position.
If you do not use a Safety Band, you should insulate your
cables with tape to protect them.
If the rod holder is in the wrong position, the holder plate must
be reversed.
To do this follow the steps below.
STRETCHED MOTOR
RETRACTED MOTOR
• Upright Plate
• Horizontal plate
