10
5
6
5
8
4
A
B
10
11
7
C
EN
03. INSTALLATION
INVERT BAR POSITION
•
INVERT MOTOR
•
APPLY SPRINGS
Unlock the motor (page 5B).
See page 14 to see how many
springs you need to use for the size
of extendable bar you will use.
Loosen the screw that secures the motor tip to the
lever as well as washers and socket.
Secure the spring(s) to the lever,
following the indications in this
table, using screws and washers
according to drawings
A
,
B
or
C
above.
Remove the motor fixation bolt to the bottom plate
by loosening the screw and female.
Slide the rear of the motor
into the side hole, and
replace the bolt and female
bolt.
NOTE: Fully tighten the bolt,
and then unscrew it 1mm to
loosen slightly.
Retighten the motor tip to the lever in one of the
holes on the other side with the same bolt, washers
and socket.
Once attached
to the lever, fully
extend the engine
and lock it so that
the lever is in this
position.
Pass the M8 rod of each spring used through the respective hole in the lower plate, and place two
M8 females in each spring used.
In this step, do not tighten these females to make it easier to move the bar during installation. See
page 13 for how to adjust the springs.
3
9
4
10
5
6
7
8
11
A ·
APPLICATION OF 2 SPRINGS IN THE SAME HOLE
B ·
APPLICATION OF 2 SPRINGS IN DIFFERENT HOLES
C ·
APPLICATION OF 1 SPRING PER HOLE
