Motorline professional MC50SE, Руководство пользователя и инсталлятора

Страница: 4 / 18

4A 4B
24V
1
1
1
1 1
2
2
2
2 2
3
3
3
3
4
4
4
4
5
5
5
5
6 7 8 9
CN1
CN2 CN3 CN4
CN5
Dipper
LS LO FO
LA
FC
LE PU
3A 3B
EN EN
01 • Safety Edge
02 • Photocells
03 • Encoder (not used)
04 • Encoder (not used)
05 • Common
01 • +24V DC Auxiliary Power Supply for LED RGB flashing light
02 • Y output
03 • R output
04 • G output
05 • B output
CN4
CN5
LED
S
LS • LED lit when the close push button is active
LO • LED lit when the open push button is active
F0 • LED off when the opening limit switch is active
FC • LED off when the closing limit switch is active
ST • LED off when STOP is active (when P6 is active)
LE • LED off when photocells are active (when P5 is active)
CN1
Courtesy light or flashing light:
08 and 09 • This output allows connection of a courtesy light or a flashing light
(see P8 in page 9B).
CN2
Limit switches:
03 and 04 • The control board needs a opening and closing limit-switches
connection (both in NC). Triggering any limit-switch will make the immediate
stoppage of the movement.
The limit-switch thriggering is visible on the display. OP (opening limit switch
activated) and CL (opening limit switch activated).
It is mandatory the use of limit switches.
CN4
Safety circuits:
01 • This input allows connection of STOP device. The device could be activeted
or desactiveted in the P6 menu (page 8B).
02 • This input allows connection of photocells. The device operates according
to programming set in the P5 menu (page 8A)
Shunt application is not necessary.
04 • It allows the connection of a pushbutton of singular botton for up and
down of the door.
CN5
01 • Auxiliary output for flashing light or 24V DC LED.
Open collector for the management of auxiliary functions:
02 • The y output is activated in the initial 2 seconds of the movement to control
the second capacitor.
03 • The R output is activated in intermittent mode, only in closing phase.
04 • The G output is activated in intermittent mode, only in opening phase.
05 • The B output is activated in intermittent mode, only in pause time.
Dipper
The dipper indicates the motor's power rating. Put the dipper in this position.
PROGRAMMING PRE-RECOMENDATIONS
02. THE CONTROL BOARD
02. THE CONTROL BOARD TECHNICAL SPECIFICATIONS
To enhance knowledge about the control board operation, before proceeding to the
setup, give special attention to the instructions that follow.
PROGRAMMING PRE-RECOMENDATIONS
02. THE CONTROL BOARD