Motorhispania MH7 Naked, Руководство по ремонту

Страница: 63 / 138

71
5 ELECTRICAL SYSTEM
8.2. Modifi cations allowed to user (input #5 discon-
nected)
8.2.1. Distance unit measurement regulation
The display the symbols km/h and mph will be shown
and the selected value will be shown fi rst blinking (f=1Hz,
Duty=50%) (picture 8-2).
Pressure on Set button causes the change in shown
blinking unit, while the Mode button pressure, in corres-
pondence of blinking unit, allows to select the same
unit and the passage to following screen (or going out
from regulation, depending on #5 input).
The information concerning the selected measurement
unit is saved in memory.
Obs. 8-1: Changing measurement unit will cause the
conversion of TOTAL and will set to 000.0 TD.
Obs. 8-2: Once inside the regulation menu:
• If 20 sec. will pass without the button mode is pushed, or
• If the vehicle is turned on (speed>0), or
• If the key is turned OFF
The system will be automatically taken to the sta-
dard operating mode and the modifi cations possibly
produced will be lost.
8.3. Modifi cations allowed to the factory (input #5
connected to gnd)
8.3.1. Wheel circumference modifi cation
The display is introduced as shown in picture
8-3, where the information of wheel circumference
is visualized on digit 13÷16, preceded by the letter “crf”
on digit 10÷12.
It’s possible modifying the various digits which
constitute the value of the wheel circumference,
leaving from the most signifi cant digit and moving in
series towards the least signifi cant digit.
Starting from the selected data (that will be shown blin-
king with f = 1 Hz, Duty = 50%), a short pressure
of the Set button will allow an unitary increase,
while a long pressure of Mode button will allow to
select a different digit.
The selected circumference of the wheel is saved in me-
mory.
Picture 8-3: wheel circumference
regulation
Picture 8-2:distance unit misure
regulation