© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
REVISION 5-20-21
www.motorcitywashworks.com
20
For a TWO PHOTO-EYE configuration, pull
the two emitter/receiver cables through the photo-eye tree. Connect
to the appropriate photo-eye:
CONNECT “ENTR” CABLE TO ENTRANCE SIDE RECEIVER/EMITTER PHOTO EYE.
CONNECT “MIDL” CABLE TO MIDDLE RECEIVER/EMITTER PHOTO EYE.
***NOTE: RECEIVER PHOTO-EYE TREE IS TO BE INSTALLED ON THE PASSENGER’S SIDE LEG,
THE EMITTER PHOTO-EYE TREE IS TO BE INSTALLED ON THE DRIVER’S SIDE LEG***
Pic #34: Receiver Photo-Eye Cables
Pull
the power and the control cable behind the box and up to the ceiling. Connect each cable in its own separate
junction box.
Like
the Top Profiler unit, pull
the air lines and connect to the “Y” fittings at the passenger upper side corner.
YOUR 50-90HP SIDE PROFILER® DRYER REQUIRES A POWER SOURCE OF 120VAC.
CONNECT THE POWER CABLE TO A SEPARATE 120VAC CIRCUIT.
YOUR 30-90HP SIDE PROFILER® DRYER ALSO REQUIRES
A “READY” SIGNAL TO BRING THE NOZZLES DOWN.
THE SIGNAL COMES FROM THE CAR WASH CONTROLLER.
THE SIGNAL HAS TO BE PROGRAMMED FOR EACH CAR. THE
SIGNAL CAN BE ANYTHING BETWEEN 24 TO 240VAC OR DC SIGNAL.
BOTH SIDE AND TOP PROFILER® DRYERS WILL EXTEND WITH THE
SAME READY SIGNAL.
