Motomaster ELIMINATOR 11-1586-4, Руководство пользователя

Страница: 26 / 56

24
TROUBLESHOOTING/FAILURE CODES
(cont’d)
v PROBLEM POSSIBLE CAUSE REASON/SOLUTION
Short or no start cycle when
cranking engine.
Drawing more than the engine
start rate.
Crank time varies with the
amount of current drawn. If
cranking draws more than the
engine start rate, crank time
may be less than 3 seconds.
Failure to wait 4 minutes (240
seconds) between cranks.
Wait 4 minutes of rest time
before the next crank.
Clips are not making a good
connection.
Check for poor connection at
battery and frame.
AC cord and/or extension cord
is loose.
Check power cord and
extension cord for loose fitting
plug.
No power at receptacle. Check for open fuse or circuit
breaker supplying AC outlet.
Charger may be overheated. The thermal protector may have
tripped and needs a little longer
to reset. Make sure the charger
vents are not blocked. Wait and
try again.
Battery may be severely
discharged.
On a severely discharged
battery, charge for 10 to 15
minutes in the 55 A charge rate
to help assist in cranking.
Charger will not turn on when
properly connected.
AC outlet is dead. Check for open fuse or circuit
breaker supplying AC outlet.
Poor electrical connection. Check power cord and
extension cord for loose fitting
plug.
Function switch is in the OFF
position.
Turn function switch on.
The battery is connected and
the charger is on, but is not
charging.
Clips are not making a good
connection.
Check for poor connection at
battery and frame. Make sure
connecting points are clean.
Rock clips back and forth for a
better connection.
The measured current is much
lower than what was selected.
The charger reached the
maximum voltage and is
reducing the current.
No problem, this is a normal
condition.
If the solutions listed do not eliminate the problem or for information about troubleshooting or
replacement parts, call 1-800-528-6817.
TROUBLESHOO
TING
/F
AIL
URE
C
ODES