Motomaster ELIMINATOR 11-1586-4, Руководство пользователя

Страница: 25 / 56

TROUBLESHOO
TING
/F
AIL
URE
C
ODES
23
TROUBLESHOOTING/FAILURE CODES
(cont’d)
v PROBLEM POSSIBLE CAUSE REASON/SOLUTION
Battery clips do not spark when
touched together.
The charger is equipped with
an auto-start feature. It will not
supply current to the battery
clips until a battery is properly
connected. Therefore, the
clips will not spark if touched
together.
No problem; this is a normal
condition.
The charger is making an
audible clicking sound.
Circuit breaker is cycling. The settings may be wrong.
Check the charger settings.
Battery is defective. Have the battery checked.
Shorted battery cables or clips. Circuit breaker cycles when
current draw is too high. Check
for shorted cables or clips and
replace if necessary.
Severely discharged battery, but
otherwise it is a good battery.
The battery may not want to
accept a charge due to a run-
down state. Allow charging to
continue until battery has a
chance to recover sufficiently
to take a charge. If more than
20 minutes, stop charging and
have the battery checked.
Connections are reversed. Shut the charger off and correct
the lead connections.
Charger makes a loud buzz or
hum.
Transformer laminations vibrate
(buzz).
No problem, this is a normal
condition.
Shorted diode assembly or
output rectifier assembly (hum).
Have charger checked by a
qualified technician.
CONNECTED (red) LED is
not on.
Clips are not making a good
connection to the battery.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Connections are reversed. Unplug the charger and reverse
the clips.
Battery is defective (will not
accept a charge).
Have battery checked.
CONNECTED (red) LED is
blinking.
Indicates the charger is in abort
mode.
See “Aborted Charge” in the
Other LEDs and Features
Section.