AGITO
29
Motion Impossible Ltd.
www.Motion-Impossible.com
+44 1454 501010
29
AGITO Owners’ Manual v1.3 Firmware r4.13
TOWER: ATTACHING CAMERA GIMBAL TO TOWER
Remove the Quick Release Plate from the Tower
Loosen the 3/8
th
inch lock and lift out plate
Align the Quick Release Plate with the holes on the Remote Head
Inset and tighten the four bolts,
be careful to use the correct length bolts
Locate the Quick Release Plate back into the top of the Tower
Ensure the Plate is located correctly, tighten the 3/8
th
Locking Bolt
TOWER: USING THE POWER & ETHERNET PASS-THROUGH
The top of the Tower has two Lemo ports:
(A) 3-pin Power pass-through
(B) 8-way Ethernet pass-through
The base of the Tower has three Lemo ports:
(A) 3-pin Power pass-through
(B) 8-way Ethernet pass-through
(C) 4-pin Tower Control to AGITO Core
Note: Pinouts for these connectors are located at the back of this manual.
ATTACHING PAYLOAD: MITCHELL MOUNT
Attach the two side plates to the CORE
Inset and tighten the four 3/8
th
inch bolts
Place the Mitchell Mount on to the side plates
Inset and tighten the four bolts
ATTACHING CHEESE-PLATE
The cheese plate is simply attached with 4x M5 countersunk screws as
shown. The cheese plate comes installed from factory as standard.
ALWAYS ensure the Payload is properly and securely fixed to the
AGITO Tower, use a minimum of four fixture points.
