www.moteck.com
13
Wire definitions: SPL
Connect Red to positive.
Connect Black to negative.
Do not swap the polarity.
Input voltage: 12/24V±20%
Connect Red to positive (same as V+) to extend.
Vin= 5~32V
Power
cable
Description
Wire color
Black
Red
Yellow
White
The recommended voltage is the same as V+, 12/24V±20%
1. Potentiometer specification:
- 10K ohm, 10 turns.
- Tolerance ±5%
2. Output voltage: The voltage (resistance) between
Blue and White increases linearly from about 0 when
the actuator extends, and decreases when it retracts.
3. There are different resolutions according to the stroke
length (as table below)
Note: For strokes over 950mm, the SHL option is recommended.
Actuator extends
Y
W
B
Blue
Stroke range (mm)
100~450
451~950
Red
Connect Black to positive (same as V+) to extend.
Vin= 5~32V
Black
Definition
V-
Actuator
extends
Vin
Orange
Retract EoS
output
Green
Extend EoS
output
GND
POT output
V+
Actuator
retracts
Output= GND (Normally close circuit)
Output= Vcc (End of Stroke, open circuit)
The stroke limit switches are open collector circuit, and the arrival
signal output is not potential free. A 10KΩ pull-up resistor should be
applied in user’s control circuit.
Recommended input voltage is 5~24V
Resolution (ohm/mm)
20
10
Signal
cable