How to Edit LO
LO is Incorrect
You can edit the LO if you find that the length saved after calibration requires some
further tuning. You may see the print's transition's start too early or too late, and
adjusting the transition target in Canvas, PrusaSlicer/Slic3r doesn't have an effect.
To determine if this is the case, you can do the following next time you start a print
(the print does not need to complete, and you can cancel shortly after).
a) Load your extruder with clear or white filament before loading the filament from
Palette. This will prime the nozzle and make observing the filament from Palette
easier (please do not use clear or white in Palette).
b) Start the .mcfx/.maf file on Palette and proceed with the steps provided on the
screen to load filament to the extruder. You will come to the loading step that asks
you to jog a specific number of millimeters before starting the print (based on the
saved LO). Jog the filament slowly, and stop as close to 0 as possible.
c) After confirming that loading is complete and before starting the print, take a look
at the filament that has been extruded.
If you see that all of the clear or white
filament and some (>5cm) of the colored filament from Palette has been
extruded, the LO may be too long and needs to be decreased.
Incrementally
decrease your LO manually. Start with 5-10mm at a time. Cancel the print, and
proceed to the next step.
69 of 74
