Morso P30, Инструкция по установке и эксплуатации

Страница: 17 / 21

32 33
Sprog
Sprog
3.2 Beskrivelser af Alarmer
Alarm Reason Remedy
AL01 BLACKOUT Power cut during the operating
phase Press key 3 to turn off and on
the pellet stove again (check
electrical connection). Refer to
your Morsø dealer if the pro-
blem persists.
AL02
ALARM SMOKE SENSOR The smoke sensor is not functioning
correctly Refer to your Morsø dealer
AL03
ALARM LOW FLAME The pellet hopper is empty/ poor
pellets/ chimney defect Check that there are pellets in
the hopper
AL04
DEFECTIVE SMOKE EX-
TRACTOR The rev counter on the smoke ex-
tractor is not functioning or is not
connected correctly. The fan is
blocked. Refer to your Morsø dealer
AL05 NO IGNITION The pellet hopper is empty.
Defective setting of timber pellets
and draught in the ignition phase.
Ignition for ignition is defective or
not in position
Check that there are pellets in
the hopper.
Refer to your Morsø dealer
Refer to your Morsø dealer
AL06
NO PELLETS The pellet hopper is empty
The auger is not transferring pellets
Too few pellets or too high air sup-
ply
Check that there are pellets in
the hopper.
Empty the pellet hopper to
check whether an object has
fallen into it and preventing
correct operation of the auger.
Adjust combustion (see page
23)
Refer to your Morsø dealer if
the problem persists.
AL07
RESET THERMAL Thermal sensor with manual con-
nection/ reconnection is activated.
Convection fan is defective
Combustion in the burn pot is not
optimal
Reset thermal sensor by pres-
sing the button behind the sto-
ve (see page 34)
Refer to your Morsø dealer
Turn off the pellet stove, clean
burn pot and adjust combu-
stion
Glass fibre rope to doors
In time, the gaskets in the lid will become worn and should be replaced as necessary to avoid
uncontrolled combustion. Use original Morsø sealing rope.
Glass pane
Optimal combustion leads to no, or only minimal, soot on the ceramic glass. If the glass be-
comes heavily sooted due to faulty operation/ settings, it can easily be removed using Morsø
Glass Cleaner.
The glass must be cold when this cleaning takes place.
A grey transparent film can develop over time on the inside of a the glass, which cannot be
removed.
We recommended the use of Morsø Glass Cleaner.
Vacuum cleaning the pellet hopper
About once a month, the pellet hopper should be vacuum cleaned to remove wood dust.