MORryde Aie1, Руководство пользователя, Страница: 21 / 28

574.293.1581
•
MORryde.com
•
PAGE
20
Nothing happens when
making an adjustment with
the remote - When first powering on the remote, the Bluetooth
connection is established in the background.
Changes to the desired pressure can be made
while connecting, but the adjustment command
won’t be sent until the Bluetooth connection is
complete and the signal strength icon is visible in
the upper left corner of the screen. Wait for the Bluetooth connection to complete. The
last adjustment will automatically be made once the
connection is established.
Unable to connect to the
module with the remote - Remote batteries are low Check the remote battery icon. Change the
batteries if necessary (See
Replacing Batteries
).
- Blown 20A fuse Check the 20A fuse. Enter the pairing screen on the
remote or the on the mobile app > Devices and see
if the device name (iFLEX#) is visible via Bluetooth.
- Weak Bluetooth signal Ensure the module is mounted forward of the rear
axle. Move the module to a location not shielded
by metal.
- Remote has become unpaired from the module Re-pair the remote by removing and reinstalling the
20A fuse. The module will be in pairing mode for 3
minutes after power is applied.
System does not maintain
and/or reach ride height 21 Large leak in the system Locate and correct the leak (See
Finding Air Leaks
and Fixing Leaks in Barbed Fittings
and
Fixing
Leaks on PTC Fittings
). Remove and reinstall the
20A fuse to reset the fault.
- The trailer could be overloaded If the air pressure in the system is at its max
pressure of 80 PSI (5.5 BAR), the system will stop
inflating.
Compressor runs often
without commanding an
inflate adjustment 22 Small air leak in the system Locate and correct the leak (See
Finding Air Leaks
and Fixing Leaks in Barbed Fittings
and
Fixing
Leaks on PTC Fittings
)
Problem
Error
Code
Cause Solution
If the ignition wire is not connected, the system will only maintain a preset when the vehicle starts moving or is connected to the remote or mobile app.
Compressor doesn’t
run when inflation is
commanded 1 Battery voltage is too low (below 9 volts) Check the batteries.
2 Battery voltage is too high (above 18 volts) Check the batteries and charging system.
3 Module temperature is too cold Allow module to warm up.
4 Module temperature is too hot Allow module to cool down. Move module location
away from heat sources.
15 Compressor overcurrent Use the mobile app to clear the error code.
Disconnect the compressor and test on the bench
using 12 volts.
18 Compressor duty cycle limit has been reached Allow the compressor to sit idle until the cool down
period (15 minutes) has been reached.
19 Blockage in the compressor or system which is
preventing air flow Check for system blockages or frozen moisture in
the air lines. Remove and reinstall the 15A fuse to
reset the fault. One mobile device can pair with any
number of modules; there is no limit.
- Bad ground, poor wire connections, bad
compressor, or bad module Disconnect the compressor and test on the bench
using 12 volts.
System does not exhaust
when deflation is
commanded 1 Battery voltage is too low (below 9 volts) Check the batteries.
2 Battery voltage is too high (above 18 volts) Check the batteries and charging system.
3 Module temperature is too cold Allow module to warm up.
4 Module temperature is too hot Allow module to cool down. Move module away
from heat sources.
Nothing happens when
vehicle is turned on - If the ignition wire is not connected, the system will
only maintain a preset if the truck starts moving or
is connected to the remote or mobile app. Connect the optional ignition wire if desired.
Connect to the module using the remote or mobile
app to wake the system up for quicker adjustments.