MORryde Aie1, Руководство пользователя, Страница: 13 / 28

574.293.1581
•
MORryde.com
•
PAGE
12
figure 4
STEP 3
Use the up and down arrows to choose the module.
Press • (P1) to begin pairing process.
STEP 4
The device will indicate “pairing” when it is connecting
to a device. There is no Bluetooth password.
STEP 5
Once complete, the remote will either indicate “pairing
successful” which means the devices are paired, or
“pairing unsuccessful” which will require the user to pull
and reinstall the fuse and try again. Once the remote is
connected to the module, it will automatically connect
each time the module is active and the remote is
woken up.
NOTE:
To enter the menu, press the inflate and
deflate buttons at the same time (fig. 1).
Units
Select "Units" from the menu to switch between PSI
and BAR
(fig. 4) . The factory default is PSI.
Troubleshoot
Select "Troubleshoot" from the menu to see system
error messages. For more information about error
messages, review the section in this manual called
Troubleshooting Guide.
Pair the Module to the Remote
The module will enter pairing mode for three
minutes after the fuse is installed. Once a device
is paired, it will automatically connect if no other
device is already connected. The remote will go
into sleep mode after 40 seconds, at which time it
will disconnect from the system.
NOTE: The remote comes with batteries installed.
To operate the device, slowly pull the tab out of
the battery compartment.
STEP 1
To initiate pairing mode, remove the fuse, wait five
seconds, and reinstall.
STEP 2
Press a button to wake up the remote. It will
automatically go to the pairing screen if it is not
already paired with a module. Use the up and down
arrow buttons to navigate the pairing menu. Select
the device that matches the module serial number
(figs. 2 & 3).
figure 2
figure 3