Morningstar SUNSAVER DUO, Инструкция по установке и эксплуатации

Страница: 7 / 76

ENGLISH
7
Mounting
NOTE: When mounting the SunSaver Duo, ensure free air
flow through the controller heat sink fins. There should be
at least 3 inches (75 mm) clearance above and below the
controller to allow for cooling. If mounted in an enclosure,
ventilation is highly recommended.
WARNING: Never install the SunSaver Duo in a sealed
enclosure with vented (flooded) batteries! Do not install in
a confined area where battery gasses can accumulate.
RISK OF EXPLOSION!
1. Locate the SunSaver Duo on a vertical surface protected from direct
sun, high temperatures, and water.
2. Place the SunSaver Duo in the location where it will be mounted.
Verify that there is sufficient room to run wires and that there is
ample room above and below the controller for air flow.
11
3.3 M ounting
NO TE:
When mounting the SunSaver Duo, ensure free air flow through the controller
heat sink fins. There should be at least 3 inches (75 mm) clearance above and below
the controller to allow for cooling. If mounted in an enclosure, ventilation is highly
recommended.
W ARNING
: Never install the SunSaver Duo in a sealed enclosure with vented
(flooded) batteries! Do not install in a confined area where battery gasses can
accumulate. Risk of explosion!
1. Locate the SunSaver Duo on a vertical surface protected from direct sun, high
temperatures, and water.
2. Place the SunSaver Duo in the location where it will be mounted. Verify that
there is sufficient room to run wires and that there is ample room above and
below the controller for air flow.
Figure 3. Mounting and cooling
3. Use a pencil or pen to mark the four (4) mounting hole locations on the mounting
surface.
4. Remove the controller and drill 3/32” (2.5 mm) holes in the marked locations.
5. Place the controller on the surface and align the mounting holes with the drilled
holes in step 4. Secure the controller in place using the mounting screws
(included).
Figure 3. Mounting and cooling
3. Use a pencil or pen to mark the four (4) mounting hole locations on
the mounting surface.
4. Remove the controller and drill 3/32” (2.5 mm) holes in the marked
locations.
5. Place the controller on the surface and align the mounting holes with
the drilled holes in step 4. Secure the controller in place using the
mounting screws (included).