12
Operation 2018-02-21
Settings
3. Memory Bar
The Memory Bar can be set anywhere up to APEX.
The Memory Bar can be set during treatment to mark
a point of interest inside the canal such as the begin-
ning of a curve, a certain distance from the apex, or the
point to change fi le size for enlargement.
Method
Insert the fi le up to the desired point and then press the
Set Switch. This will cause another bar to fl ash on and off
at a slightly slower speed that the main Flash Bar. This will
not change the point where the alarm is activated.
4. Beeper Volume
The volume of the beep can be set for Loud or Soft, or
it can be turned off.
Method
Hold down the Set Switch and turn the Root ZX
mini on. This will change the setting of the beep
from Loud to off. Repeat the procedure to change
it from off to Soft. The setting will be memorized
and stay the same the next time you turn the unit
on.
• The Memory Bar should only be used as an estimate. You may need to change it during enlargement and
cleaning. If there seems to be some problem, stop using the instrument immediately.
• Check the settings displayed after selecting memories.
• The Memory Bar cannot be set beyond the Apex.
• The Memory Bar can be set at a different point for each of the 3 memories.
• The Memory Bar will stay wherever you set it until the Root ZX mini is turned off, but it will not be memo-
rized.
• The volume of the beep that sounds when the unit is turned on cannot be adjusted.
Memory Bar
starts fl ashing
File position
