53
2
1
Access the Tools menu (see Expert User Options Section in this manual)
2
Select the two marked arrows to move the blade to the “Top Dead Centre”
3
Raise the exit guard
4
Using a 5mm allen key, unlock the socket head screws positioned at each end of the
creasing blade.
5
Rotate the blade adjustment cams until they are just tight, and then back off slightly
before tightening the socket head screws.
6
The diagram below demonstrates the adjustment of the blade pressure
NOTE:
If the crease damages or cuts through the paper, decrease the crease pressure by rotating
the adjustment cams a small distance towards the infeed side of the machine. If the paper
cracks along the spine when it is folded, increase the crease pressure by rotating the
adjustment cams a small distance towards the exit side of the machine.
Setting Crease Pressure
