24
1
Setting the Crease Tilt Knob (continued)
DigiFold Pro 385 Knob Adjustment Procedure - Blade 2
1
From the GUI, select a one-crease
custom fold (see section 2) and load
paper.
2
From the fold configuration sub-menu,
change both the folding offset values
to 0 (see section 2).
3
Make sure that the folding option is on
and run a test sheet (see section 2).
NOTE:
Wrong crease positions are
marked in red, correct crease
position is marked in green.
Blade 2 knob
4
If the crease is not in the correct
position (see figure 2), adjustment
is needed. If the crease is in the
correct position skip steps from 5 to
9.
5
Rotate the left knob
counterclockwise to loosen it.
6
Move the knob slightly, either to
the left or to the right depending on
whether the crease is tilted either to
the right or to the left.
7
Rotate the knob clockwise to
secure it.
8
Run a test sheet to check if the
crease is now perpendicular.
9
Repeat steps 5 to 8 if necessary.
Feed direction
figure 2
Blade 2
