Moog IMI220-145D001, Руководство пользователя

Страница: 85 / 113

PARISON CONTROLLER
moog
Moog Italiana srl - Bergamo MAN145-UM-D01A-EN 85
4.10 Work Extruder.
Figure 86
Work Extruder n.: Work Extruder page n° (n° = 1 to 2).
Access: From Main Menu 1 key F5 (Extruder 1) or F6 (Extruder 2).
Use: It is possible to decide whether to use the extruder or not and which channel it should be associated to. It can
be associated to:

A thickness regulator in continuous extrusion.

A thickness regulator in time accumulation.

Accumulator.
It is possible to decide whether the extruder is driven by an analog or digital command. In case of analog command
the output voltage of a channel is the speed setpoint. In case of a digital command two digital outputs allow increase
or decrease of speed.

Extruder with analog command:
o
It is possible to calibrate the input with: 0 speed voltage, maximum speed voltage, and maximum
speed. The speed is expressed in RPM.
o
It is possible to calibrate the output with: maximum speed, voltage to reach maximum speed.
o
These setpoints can be setup: speed to be reached, rise ramp in RMP/sec., descent ramp in
RPM/sec., minimum speed, maximum speed.

Extruder with digital command:
o
You can setup the maximum time for digital output. (manual command or maximum velocity
control).