H*38DF PRC Panorama Indoor Gas Fireplace
Page 36
XG0211 - 151126
Operation
Section:
Continuous Pilot (CPI) Selection (Optional)
In cold weather climates, the pilot burner can stay on
continuously to prevent condensation or cold air temperatures
near the fireplace glass. Note, some jurisdictions do no permit
use of continuous pilot system. Check local codes or contact
your Montigo dealer.
With the system in "off" position press the Mode Key, see Figure
30, to index to the CPI mode icon, see Figure 30n. Pressing the
Up Arrow Key will activate the Continuous Pilot Ignition mode
(CPI). Pressing the Down Arrow Key will return to IPI. A single
"beep" will confirm the reception of the command.
NOTE:
- Requires CPI/IPI jumper cable installed, see page 20.
Key Lock
This function will lock the keys to avoid unsupervised operation.
To activate this function, press the Mode and Up Keys at the
same time, see Figure 30o. To de-activate this function, press the
Mode and Up Keys at the same time.
Remote Control
When the Remote Control batteries are low, a Battery Icon will
appear on the LCD display of the Remote Control, see Figure
30p, before all battery power is lost. When the batteries are
replaced this icon will disappear.
Control Module
When the back-up batteries are low, a "double-beep" will be
emitted from the IFC when it receivers an On/Off command from
the Remote Control. This is an alert for a low battery condition of
the receiver and after that no more commands will be accepted.
When the batteries are replaced the "beep" will be emitted from
the receiver as soon as powered.
Low Battery Power Detection
The life span of the batteries depends on various factors: quality
of the batteries used, the number of ignitions of the appliance,
the number of changes to the room thermostat set point, etc.
Figure 30n.
Continuous Pilot / Intermittent Pilot Selection
Figure 30o.
Key Lock
Figure 30p.
Low Battery Power Detection
