© 2011 Monte Carlo Fan Company
3/1/2012
4
Install 3 screws to hold glass to fan
housing. Do not overtighten as this
could crack the glass.
10
Pull lead wires and safety cable out
from the yoke about 3”.
12
Raise lead wire, safety cable, and
downrod up and align with slot for
pin in bottom of arch yoke. Push pin
into hole in downrod.
After putting
in pin don’t twist downrod
.
Make
sure pin is fully engaged in slot.
14
Tighten set screws to hold downrod
securely in the arch yoke.
15
Place downrod into the arch yoke and
align the slot in arch yoke and the
hole in the downrod.
13
Place arms over the fan housing.
Make sure the arms with electrical
connection plugs are next to the
plugs on the fan housing.
16
Remove pin from downrod and save
for later step 14. Push the yoke cover
onto downrod. Thread lead wires and
safety cable through the downrod.
11
Close up for showing tab and screw
holes of fan body to place arch arms
over for arch installation.
17
Align holes in arch arm and slot for
tab with holes and tab on fan body.
Start all screws in the arch arm
brackets.
18
