Install downrod into yoke. Align hole
in downrod with hole in yoke and
install cross pin. Install keeper into
cross pin.
Place canopy and then yoke cover on
downrod. Thread leadwires and safe-
ty cable through downrod as shown.
7
8
Tighten 2 downrod set screws and
lock nuts.
9
Raise fan with downrod assembled to
the ceiling bracket and hang fan
assembly. Be sure to rotate the
downrod ball so that the notch in the
bracket engages the slot in the ball.
12
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
11
Fan and light kit combinations over 35 lbs,
in both flush and downrod mode the safety
cable must be installed into the house struc-
ture beams using the 3” lag screws,washers,
and lock washers. provided. Make sure that
when the safety cable is fully extended the
lead wires are longer than the cable and no
stress is placed on the lead wires.
10
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Install remote receiver by sliding into opening in
the Mounting bracket. Make sure that the dip
switches on the Transmitter and the Receiver
are set to the same position. See Fig 38 for
remote operation
13
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.
white
black
14
Lift Canopy to ceiling aligning the
key hole slots with the screws on the
bottom of the Mounting bracket.
Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws
to secure the Canopy. See inset for
Keyhole shape
15
Attach blades to motor using screws
and washers in hardware bag and
tighten screws securely.
16
Loosen 3 screws and remove 1 screw
from motor plate. Save removed
screw for use later.
17
Install light plate to fan by twisting
plate with key hole slots into place.
Replace screw removed and tighten
the 4 screws securely.
18
