Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
23
Remove 1 screw and loosen other 3.
Twist and remove plate.Then remove
body of fan.
28
To install fan witout light kit ,attach
switch cap into grooves and twist to
lock into place.
Loosen 2 screws and remove 1 screw
from motor plate. Save removed
screw for use later.
22
Install light plate to fan by twisting
plate with key hole slots into place.
Replace screw removed and tighten
the 3 screws securely.
24
Install glass with finial cap and tight-
en in direction of arrow.
26
Install 3 x 40 watt incandescent candelabra
bulbs. Bulbs included. WARNING: Over
lamping the fan will result in the fan
lights shutting down until the proper
wattage of bulbs are installed.
Reset the lights by turning off the wall
switch, breaker,or by remote. Replace
bulbs with the correct wattage bulbs, turn
the power on.
25
20
Align seams as shown above.
(Blades not shown
21
Align the arrow from light kit cover-
with the light pan. All 3 arrows
should be aligned.
19
Align seams
If installing light kit skip step
If installing light kit skip step
20 & 21
20 & 21
Remove lock nuts and screws on
yoke.
Remove keeper from cross pin and
then cross pin from yoke.
29
30
Remove 8 screws from the flywheel.
Save for later. Remove the flywheel.
27
Flush mount installation
