Insert house wires through center
hole.Install the mounting plate to the
outlet box.Use only the screws pro-
vided with the outlet box.
38
Hang motor from hook on the
mounting plate. Use the closed
hole.Place receiver in the hanging
plate.
40
Separate from bracket.
34
Remove screws with wrench.
33
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.
white
black
42
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
41
Place receiver into the lower hang-
ing plate.
39
Remove the yoke from the motor by
removing 6 screws.
31
Remove the yoke from the mounting
plate.
32
Stick the plastic plate onto the hang-
ing bracket aligning the holes as
shown above.
35
Thread safety cable through center
hole of the mounting plate. Thread
your house wires through center hole
also.These will be needed for wiring
of the fan.
36
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
37
Safety cable installation
Safety Cable
Lag Screw
Lag Screw
Safety Cable
Washer
Lock Washer
