3.3 Programming
A Program (Bank) is a sequence of different Scenes (or steps), that will be
performed one after another. Programs can consist of up to 8 Scenes each.
3.3.1 ENTERING PROGRAM MODE
1. Press the PROGRAM button repeatedly until the LED blinks.
3.3.2 CREATE A SCENE
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank
memories on the controller and each bank can hold 8 scene memories. The
controller can save 240 scenes total.
1. Press the PROGRAM button repeatedly until the LED blinks.
Note: If the Blackout LED is illuminated, press the BLACKOUT button to
deselect it.
2. Position the SPEED and FADE TIME sliders all the way down.
3. Select the SCANNERS you wish to include in your scene.
Note: You can select more than one fixture.
4. Compose the Scene by moving the sliders and wheel.
12
Note: You can access Channels 9-16 by pressing the
PAGE SELECT
button.
This is necessary for fixtures that use more than 8 channels of control.
5. Tap the MIDI/REC button.
6. Choose a BANK (01~30) to change, if necessary.
Note: There are 8 scenes available in every Bank.
7. Select a SCENES button to store.
Note: All LEDs will flash to confirm. The LCD display will now indicate the Scene
number and Bank number in use.
8. Repeat steps 3 through 7 as necessary. Up to 8 scenes can be recorded in a
Program
9. To exit Program mode, hold the PROGRAM button.
Tip! Press the
FINE
button, activate the wheel or slider by moving it, then use the
BANK UP
and
BANK DOWN buttons to change the values in increments of 1.
Содержание 612120
Страница 1: ......