All rights reserved by MONACOR
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction
manual may be reproduced in any form or by any means for any commercial use.
5.1 Adjusting the channel
As some frequencies may already be used by
other wireless transmission systems at the
place of operation, it is recommended to
leave the transmitter switched off while the
channel of the receiver is adjusted in order to
make sure that the transmission channel
selected is free and no interference will occur.
1) Adjust the channels with the arrow buttons
(6): button
for channel selection UP,
button
for channel selection DOWN.
(For quickly going through the channel
numbers, keep the button pressed).
If the LED (2) shows green after the
channel adjustment when the transmitter
is switched off, interference signals or sig-
nals from transmitters of other wireless
systems are received. In this case, set the
receiver to a different channel.
2) When an interference-free channel has
been selected for the receiver, switch on
the transmitter and set it to the same chan-
nel (
→
operating instructions of the trans-
mitter).
Note: In case of transmitter ATS-16T, the
channels are marked 0 to F:
Channel 0 corresponds to channel CH 1,
Channel 1 corresponds to channel CH 2,
…
Channel F corresponds to channel CH 16.
During operation it is possible to briefly in -
dicate the radio frequency for the channel
adjusted: As long as the button
(8) is kept
pressed, the display will indicate the fre-
quency instead of the channel.
6 Specifications
Radio frequency range: 863.1 – 864.9 MHz, divided
into 16 channels
(
→
table below)
Accessory: . . . . . . . . . 1 mono earphone,
dynamic 32 Ω system with
1.2 m cable
Connections: . . . . . . . . 1 mono earphone output
via 3.5 mm stereo jack,
1 mono line output via
3.5 mm stereo jack
Power supply: . . . . . . . 2
×
1.5 V battery of size AA or
2
×
1.2 V rechargeable bat te ry
of size AA
Dimensions: . . . . . . . . 64
×
175
×
37 mm
(with antenna and belt clip)
Weight: . . . . . . . . . . . . 182 g [with (rechargeable)
batteries]
6.1 Frequencies of the channels
CH 1 – CH 16
Subject to technical modification.
CH
Frequency
CH
Frequency
1
863.1 MHz
9
863.2 MHz
2
864.1 MHz
10
864.2 MHz
3
863.6 MHz
11
863.7 MHz
4
864.6 MHz
12
864.7 MHz
5
863.3 MHz
13
863.4 MHz
6
864.3 MHz
14
864.4 MHz
7
863.8 MHz
15
863.9 MHz
8
864.8 MHz
16
864.9 MHz
9
GB
